Wi-Fi Irrigation Control


Account - Dashboard View

There are a number of ways to keep an eye on your controller, including the dashboard, reports, and configuration.

Controller Dashboard

From the controller dashboard you can:

  1. Find zone information and start, stop, and suspend zones
  2. See temperature and rainfall observations
  3. See the weather forecast
  4. See and add sensors
  5. See your controller’s status
  6. View a different controller


Zone Information

All your configured zones are listed here. To find more information about a zone, click on the zone.



This will show when the zone is next scheduled to run and for how long, and when it last ran.

To run a zone, click the Play button. You will be prompted to run the zone for its normal watering time or to choose a custom time.



To suspend a zone, click the  button, then suspend all zones. You will be prompted to choose when the suspension should end. Once a zone is suspended it will display in a lighter color on the dashboard and you can click the Pause button again to remove the suspension.




To display zone information, click the   button after hovering over the zone. This will display information including the next watering time, watering frequency and program start times.

The icon on the dashboard can be changed to display a picture of your irrigation zone.


Temperature and Rainfall

All temperature and rainfall values are calculated as the median of your weather stations.  For example, if you are subscribed to 3 weather stations, the temperature or rainfall will be the middle value. If you are subscribed to 4 weather stations it will be halfway between the two middle values.

  • weather stations:
    • If your weather stations record maximum temperatures of 45, 48 and 56 degrees, the median will be 48 degrees.
  • weather stations:
    • If your weather stations record maximum temperatures of 70, 75, 77 and 80 degrees, the median will be 76

If your temperature or rainfall readings are consistently showing a low value, go to Reports and check each weather station rainfall or temperature and adjust them accordingly.


For customers on an Enthusiast plan this will show the current and maximum temperatures for today. This is based on the median value of all the weather stations you have selected.


This panel will show you the amount of rain which fell yesterday and in the past week. This is based on the median value of all the weather stations you have selected.

If you have an Enthusiast plan, instead of yesterday’s rainfall you will see rainfall for the past 24 hours.


This area will show forecast temperature and weather conditions, including the percentage chance of rainfall, expected humidity, and expected average wind speed.


This area will show any sensors you have configured and will also allow you to add a sensor.

Controller Status

This area will display the status of your controller. If the controller is online you will see a green circle with a check, and you can hover over this to see the last time the controller was synchronized. If the controller has been offline for 30 minutes or more then you will see a red triangle with an exclamation mark. If your controller remains offline for 24 hours we will send you an email.





Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request